AuroraRob

Firstly,
I apologize in advance as I'm sure the answer to this question is out there somewhere, but after an hour of reading here, and on Tamiya's site, I still am not sure.
I am looking at getting the FF-03 Pro kit to carpet race, can someone please clarify/confirm if I can use a standard 1:10 Pro Line body, or do I need a Tamiya specific body, I will likely be running a short wheel base as it is a tight carpet track. (Any details or part numbers would be appreciated).

I also don't want all the body details (mirrors etc.) as there will likely be carnage.

Thank you in advance.

Rob

izzyracer

iTrader: (27)

Ummm, your body choice will be limited, tamiya or otherwise.

RedBullFiXX

iTrader: (34)

Any 190mm body should fit.
Don't think there are too many SHORT 190 bodies available though ?

izzyracer

iTrader: (27)

I doubt the Protoform style bodies will fit without moding the bumper plus the low profile style bodies might not work due to the gear box/front motor design.

$$$...

iTrader: (39)

I've seen a couple of FF03 Pro kits with Protoform mazda 6 bodies. fit no probs, but might have to trim the foam bumper to fit as with just about any other body.

AuroraRob

Thanks for the guideance all.

SteveM

iTrader: (165)

I have a DNA body on my FF-03 for club bashing. The front foam bumper didn't fit and I had to leave that off. I'm planning to try a TCS race soon and will run my TCS legal Tamiya EXIV sedan body.