EPIC "D3" Duo 3
#377
Tech Regular
How does the D3 compare to a lrp X12 13.5 using a Tekin ESC
Just looking for people who have run them to give me there thoughts please
#383
the stock is a 12.3 broad powerband rotor.
there are a total of 6 rotors. they are rated at high rpm, hi torque, and broad powerband and then 2 sizes. 12.3 and 12.5
i tried the 12.3 high rpm rotor and did not really like it. more testing is needed. i spoke to EA at the snowbirds and he has done some testing with the rotors. not sure if he found a better combination. i think most of the stock 1/12 guys were running the stock rotor
someone posted a chart about a week or 2 ago
there are a total of 6 rotors. they are rated at high rpm, hi torque, and broad powerband and then 2 sizes. 12.3 and 12.5
i tried the 12.3 high rpm rotor and did not really like it. more testing is needed. i spoke to EA at the snowbirds and he has done some testing with the rotors. not sure if he found a better combination. i think most of the stock 1/12 guys were running the stock rotor
someone posted a chart about a week or 2 ago
#385
#386
Jes purchased a D3 17.5 for my TC and cant seem to find a starting setup for my RS.
Medium sized asphalt track
track temps about 110-120
FDR 6.44
can someone point me in the right direction
Medium sized asphalt track
track temps about 110-120
FDR 6.44
can someone point me in the right direction
#387
Been running a D3 21.5 in a VTA for ages without an issue. Finally switched my Rubber TC to the 17.5 D3 this weekend and detonated a rotor on its 2nd run. Anybody else have this kind of problem?
#388
I had the same issue with mine and after trying what EA said still no luck. I took it apart to check it out and noticed the aluminim semi-circle slot the sensor board rotates in was very roughly cut and would not allow the feamle end of the sensor board to move freely. Just a little clean up with a hand file and smooth as butter.
#390
i run on a tight/small track and use 42 timing, 10 turbo, 2 ramp, 3000-11000 rpm, throttle profile 5 and fdr 6.0 or 6.21 (one 64p tooth)