vivo quevas

iTrader: (19)

I will trade you a .5mm spacer for the servo mount I gave you.

Typeone

iTrader: (50)

I was going to give it to George cause he bought the x chassis and top deck from me and I told him I was going to give it to him as soon as I got my TRF mount. Ill buy one off u tho.

vivo quevas

iTrader: (19)

No problem I will give you a washer I thought since you weren't going to use the mount. I am using a gold servo mount on a Tamiya car.
Maybe you could trade me the blue one for the gold one. George would understand I hope.

Mr.juarez

iTrader: (37)

Check fresno ag

Think its for the battery stop so lipo won't hit the lower side front belt

dizope

iTrader: (5)

Tim, check this post I made a few days ago.

http://www.rctech.net/forum/12447432-post5781.html

ATLASCOPCO

What o rings are being used in the gear diff now
Guys
Seem to have kyosho ones in my head
Also do you have part numbers please
Thanks

Qatmix

I use the Kyosho ones, they work well.

Here is a guide

http://www.thercracer.com/2013/07/ho...ear-diff.html?

Kellen Guthrie

iTrader: (2)

Hey guys just switched over to tamiya and bought a 417. What's a good setup to start with for the tamiya track?

Racing4Evo

iTrader: (2)

Mod or spec?

OnRDPassion

iTrader: (59)

Shoot me your email I will send you mine.

Kellen Guthrie

iTrader: (2)

13.5t to start with then i'm gonna run a 4.5.

Racing4Evo

iTrader: (2)

I can't find my setup its been a while, but it is VERY similar to this:

http://www.petitrc.com/reglages/tami...aukaa20110611/

The differences:
-LTC-R lightweight
-4mm ackerman spacer
-HPI Silver F&R
-Front Spool
-Front DCJ
Easy to drive setup that also works very well on carpet at TQ with spring and toe adjustments.

Jochim_18

iTrader: (10)

Fresno boys flooding Tamiya forum lol... On the flooting servo mount you guys need to figure out if the holes align correctly if not you need to drill extra hole to secure and to keep it from moving. Shock weight I would start with 35wt all the way around if you are running stock 17.5 at hobbytown Fresno.

nolo148

When I put .3 shims on each side of the diff and same the gears to 3.57mm, the diff feels kinda tight, not very smooth. What am I doing wrong? I'm not over tightening the screws, I'm using kyosho o rings, tamiya .1 shims and I'm using v5 out drives.

CraigM

iTrader: (34)

If everything is new then the gears just need to be run in. If the internals are not new then replace the gasket.

Also do yourself a favour and chuck the tamiya shims in the bin and use 1 x 0.3mm TDX or similar each side