gregsbox

READ HERE

Bappe

My TC6.1

or8ital

iTrader: (38)

Ran the TC6.1 today for the first time and my first time racing in over 2 years. Good car. Finished 5th overall out of 12 so not too bad for knocking off the rust.

Never did figure out my front shock situation. Lowest I could get it tweak free was 6mm. Compared everything to other tc6.1s at the track and can just not figure it out. In hindsight I should have swapped shocks with someone else to see what would have happened.

zzztech

iTrader: (7)

Hi

Can someone please show me how to cut the top deck in on my TC6?

I want to get better grip on the rear

Preferrably with a picture also

Thanks!

dodgeguy

iTrader: (208)

Yeah you bought an Associated. JUST BUSTIN YO CHOPS.

Love the blue.

red7fifty

iTrader: (3)

IMO, I'd suggest the XXXMain book, Chassis Set Up Guide....before cutting the top deck.

Jochim_18

iTrader: (10)

No need to cut the top deck just setup your suspension to your track...

burgboyz

iTrader: (70)

Have you tried taking out the 2 button head screws on the top deck near the spur? Fine tuning option prior to cutting td.

rc-goods

TC6 CVD Kit (AP-11001)



www.rcgoods.com

Geberit

http://www.rcgoods.com/products/1492...n-chassis.aspx

Will there be a Chassis like this for TC6.1?

All the best brands (Yokomo, Tamiya, Kyosho, HB, Xray) go to this design this days. The reaseo is to get flex where you require it ...

Seen some prototype in ETS Gran Canaria last week! Levanen and Hebert were not able to cahallenge the fast guys. Despite some of the best were not there they didn't make it to the a-main.

Chears

BlackStarRacing

iTrader: (40)

What is the material you have under the board on your bench?

Scottmisfits

iTrader: (7)

That looks to be the rubber mat material for the drawers or tool boxes. Should be able to find it at any hardware store.

masterhit

iTrader: (16)

Pic 1 from Birds.

Pic 2 from Birds.

Mike Slaughter

or8ital

iTrader: (38)

LOL! I was just talking about you yesterday and wondering if you were still into RC.

zzztech

iTrader: (7)

Thanks for sharing the pix Mike,

Seems like I have to cut the rear one above the pinion to fit a 36T pinion for a 21.5T motor anyway lol.