very, very cool.
i think the shocks should work just fine like that. notice that the lower mounting position is way outside so that the amount of shock travel is still adequate despite the relaxed angle. i too, would like to see the option to stand them up though.
that is a very pretty car. apparently this dude is responsible for the atlas car that i started a thread on. the atlas ym34ce or club enthuse version.
some very good ideas at work here. i would love to contact the creator and exchange ideas.
guys, also note that unless the track width is narrower than the original alex car, 28mm foams will not work if your track employs the 190mm maximum width rule. perhaps the creator had the foresight to bring the arms in 3-4 mm total to allow for spacers?
but i've got an even better idea.