1/12th Scale Wiring...(1S)
#1
1/12th Scale Wiring...(1S)
With everyone using boosters, Li-Fe and LiPo batteries, voltage regulators, sensor wires and such, there doesn't seem to be much room on 1/12th scale cars for everything.
Looking for ideas on how to lay out my electronics, and your help would be appreciated. Post pics of your clean wiring job and help inspire me to shorten wires and quit zip-tieing everything.
Cars running 1s lipo/booster/rx packs/brushless are preferred, but all 1/12 scale configurations are welcome.
Thanks!
Looking for ideas on how to lay out my electronics, and your help would be appreciated. Post pics of your clean wiring job and help inspire me to shorten wires and quit zip-tieing everything.
Cars running 1s lipo/booster/rx packs/brushless are preferred, but all 1/12 scale configurations are welcome.
Thanks!
#2
I think there is already a thread with a bunch of pics somewhere, iwill see if I can post the link on here for ya
#3
#4
you run ko stuff, should be easy to layout your electronics with the smal 408 rx.
I run the speedo on the left and the rx on the right. if you run the length of the rx allong the length of the chassis right up agains the antenna, there is room for your rx pack just to the right of that. with all ko stuff, you just need the rx pack no booster and no regulator. if you run the ko rx, i would put all the motor wires up against the antenna. i run a tekin and i have the motor wires on the 1s lipo side
I run the speedo on the left and the rx on the right. if you run the length of the rx allong the length of the chassis right up agains the antenna, there is room for your rx pack just to the right of that. with all ko stuff, you just need the rx pack no booster and no regulator. if you run the ko rx, i would put all the motor wires up against the antenna. i run a tekin and i have the motor wires on the 1s lipo side
#6
#7
there should be one in the wiring thread of donnies car. but I will take a pic of mine this evening
yes, I would run one or the other, but not both. I run a rx pack and with my ko rx, no regulator. i run a lipo rx pack, not a life one.
yes, I would run one or the other, but not both. I run a rx pack and with my ko rx, no regulator. i run a lipo rx pack, not a life one.
#8
Here's a couple
#9
man, now that OD has posted a pic, I am afraid to post mine. it will never live up to anythign OD does
#11
Like use Deans T plug or Inboard Tube ?
#13
Tech Champion
Here's mine:
#14
#15
No solder. The wires are cut and crimped with new plug parts. It is important to have a proper crimping tool, but if you do a crimped connection is as good or better than a soldered one