SpeedMerchant Rev 6
#273
sport runs the old school front end (asc block)
#274
curious about the formula front end. it looks like you adjust ride height by shimming the whole front end as a unit.
does this mean that a ride height adjustment means you must loosen and retighten fasteners that are threaded into GR/EP lower plate?
how does those threads hold up for some of us less delicate pit mechanics?
does this mean that a ride height adjustment means you must loosen and retighten fasteners that are threaded into GR/EP lower plate?
how does those threads hold up for some of us less delicate pit mechanics?
#275
yes you loosen 6 8-32 screws and insert shims and then re-tighten. bruce make the shim so that you do not have to completely remove the screws. mine last about 1 year of racing before they start to get loose. but since, I have been helicoiling some of the parts so that I don't have to worry about it anymore. i helicoil the front end, body posts, and antenna mounts right of the bat.
#282
Tech Elite
iTrader: (24)
Hay Guys I need some help . Recently at my local track the crc guys with the help of Max Kuenning have found a magical setup that has put them ahead by a few tenths a lap. If someone could give me a setup for 17.5 blinky that carries a ton of corner speed i would greatly appreciate it. I cant be having Mario Ficco Beating me on a regular basis lol.
Thanks
Ryan
Thanks
Ryan
#283
R/C Tech Elite Member
iTrader: (28)
Hay Guys I need some help . Recently at my local track the crc guys with the help of Max Kuenning have found a magical setup that has put them ahead by a few tenths a lap. If someone could give me a setup for 17.5 blinky that carries a ton of corner speed i would greatly appreciate it. I cant be having Mario Ficco Beating me on a regular basis lol.
Thanks
Ryan
Thanks
Ryan
#284
Tech Elite
iTrader: (24)
For tires they're running gray(f) and yellow (r) witch i have tried and have been running and dropped about a tenth in lap time.
Current setup is
same tires as stated above
.20 front springs
-1.5 camber
2deg. caster
4mm ride height
Red center spring
40 wt oil
red tube spooge
.20 side springs(3 turns down from top)
3.5mm ride height
.5mm pod sag
1mm pod droop
4mm rear ride height
Current setup is
same tires as stated above
.20 front springs
-1.5 camber
2deg. caster
4mm ride height
Red center spring
40 wt oil
red tube spooge
.20 side springs(3 turns down from top)
3.5mm ride height
.5mm pod sag
1mm pod droop
4mm rear ride height
#285