Hot Bodies TCX
05-17-2011, 10:43 AM
#2778
05-17-2011, 11:27 AM
#2779
The new rear hub is 2mm shorter (height) so it needs 2mm shim to get the same outer camber link height. With using smaller shims, we can lower the outer camber position if needed.
We will also release the 2.5mm upper deck, suspension blocks (FR, FF/RR for different width), shock towers, 46mm steel drive shafts, etc. I think they all will be available in a month or so.
Thanks,
05-17-2011, 12:54 PM
#2780
Sorry for the late reply on this.
The new rear hub is 2mm shorter (height) so it needs 2mm shim to get the same outer camber link height. With using smaller shims, we can lower the outer camber position if needed.
We will also release the 2.5mm upper deck, suspension blocks (FR, FF/RR for different width), shock towers, 46mm steel drive shafts, etc. I think they all will be available in a month or so.
Thanks,
The new rear hub is 2mm shorter (height) so it needs 2mm shim to get the same outer camber link height. With using smaller shims, we can lower the outer camber position if needed.
We will also release the 2.5mm upper deck, suspension blocks (FR, FF/RR for different width), shock towers, 46mm steel drive shafts, etc. I think they all will be available in a month or so.
Thanks,
05-17-2011, 01:58 PM
#2781
I just ordered the new Roche Spool... and a pair of Tamiya 46mm dogbones...
Is that the end of the impossible quest of 88914?
Will post some photos when I get it...
Is that the end of the impossible quest of 88914?
Will post some photos when I get it...
05-17-2011, 05:58 PM
#2782
05-18-2011, 07:04 AM
#2784
Sorry for the late reply on this.
The new rear hub is 2mm shorter (height) so it needs 2mm shim to get the same outer camber link height. With using smaller shims, we can lower the outer camber position if needed.
We will also release the 2.5mm upper deck, suspension blocks (FR, FF/RR for different width), shock towers, 46mm steel drive shafts, etc. I think they all will be available in a month or so.
Thanks,
The new rear hub is 2mm shorter (height) so it needs 2mm shim to get the same outer camber link height. With using smaller shims, we can lower the outer camber position if needed.
We will also release the 2.5mm upper deck, suspension blocks (FR, FF/RR for different width), shock towers, 46mm steel drive shafts, etc. I think they all will be available in a month or so.
Thanks,
A month is too long, we want it now! Very much looking forward to the hubs/susp blocksKeep us updated
05-18-2011, 08:29 AM
#2785
here are some pics for you guys.
05-18-2011, 09:43 AM
#2787
Thanks for the pics, Hiro
Do you happen to know if the factory fixed the toe-in issue that a lot of people experienced with the molded rear hubs? I switched to aluminum long ago, so I kinda stopped following it so its already been corrected, I appologize
Do you happen to know if the factory fixed the toe-in issue that a lot of people experienced with the molded rear hubs? I switched to aluminum long ago, so I kinda stopped following it
so its already been corrected, I appologize
05-18-2011, 10:59 AM
#2788
Yes the problem has been solved and it's been kinda long time since we fixed it. Please don't worry about using the existing rear hubs. Of course the new one will have no problem.
Thanks for your support.
