agarabaghi

iTrader: (25)

So i went to the LHS with my 6s pack looking to see how i would fit deans onto the 8guage wire. They told me scrap deans because i would be drawing to much amperage.

They guy told me to run Castle Creation 6.5mm bullets. Bullet connectors on batteries scare me, so i was wondering what other connector would work with 8guage wires and an extremely high amp draw?

Would the eflite ec5s work?

Setup:
SC8e
mamba monster esc
2200kv motor
46/15
6s 5000mAh 35C pack.

FREAKAH

EC5 would work but check out the last post(on connectors) on this thread...

http://www.rctech.net/forum/electric...od-etc-18.html

agarabaghi

iTrader: (25)

Everything is pointing towards keeping the bullets.

If his car is drawing over 200amp at full throttle, i can only imagine mine is as well. Looks like I will keep the bullets after all...