BMI Racing "Copperhead 12" discussion and support
#663
Where do the 3 copper ball studs go?
#664
Need some help, I am new to 1/12 scale and picked up a DB12RR used. I just ordered the copper head and new front end conversion. Is there any where that has a tunning/ setup guide for 1/12 pan cars.
Thanks for any help,
Chad J.
Thanks for any help,
Chad J.
#666
Tech Champion
iTrader: (34)
http://www.carsrcracing.co.uk/?page_id=65
http://www.markpayneblog.blogspot.com/
#667
Thanks guys, very helpful.
#669
Has anyone put any laps in with the ch 12 new front end yet? if so what are your thoughts?
#673
#674
Hey Guys I am running crc pro cuts and I am trying to center the rear axel left and right with a track width of 172. I have 1 shim on each side and the track width is about 171.8. But it isnt even from side to side do you guys just use the shims in the kit or are there different sizes. any help tips will be greatly appreciated thanks
mike
mike
#675
Hey Guys I am running crc pro cuts and I am trying to center the rear axel left and right with a track width of 172. I have 1 shim on each side and the track width is about 171.8. But it isnt even from side to side do you guys just use the shims in the kit or are there different sizes. any help tips will be greatly appreciated thanks
mike
mike