protc3

iTrader: (13)

Thanks guys.

Evoracer

iTrader: (24)

Jason, you planning on being able to supply parts for the older chassis ? Only ask because I'd like to pick up a 12RR and a CH (if I can find them) for my collection. And btw....WHEN WILL WE HAVE A NEW BMI CAR ??
Sorry Man...had to do it.

patorz31

Jason do you have any 1.8mm flexplates for the wishbone front end? I need to buy a few sets. Also need a couple of sets of rear flex plates for the rear for tuning.

protc3

iTrader: (13)

I only have 1.5mm front flex plates in stock. I have thin and thick rear flex plates in stock. Shoot me an email at [email protected] and I will get you taken care of.

cyrrus

iTrader: (5)

Hello to the Bmi world hope everything is going good in the new design. Just though I'd chime in and hope to get some info. Take care.

Drew

jgee888

iTrader: (2)

Been quiet here, any news on the new car?

patorz31

Any word on a new BMI car?

chris moore

iTrader: (96)

the last time I went to the website it was still up but the on-line store portion did not work, so I'm guessing that BMI is dead.

protc3

iTrader: (13)

Not dead buddy, just really busy. I will be back. I have alot of big contract work that is very demanding. It is hard to get the time these days to release the new car. And the frustrations of watching the latest innovations i worked a long time on get snagged really sucked. I knew i shouldnt have shown anything at Snowbirds 2 years ago.lol Word moves fast at big races and apparently, a few things must have grabbed some attention. I just wish I could have released it as scheduled. Oh well. Family comes first and my little guy needed me.

Anyway, BMI is not a fly by night small company. We have been around for 35 years and growing at a rapid pace. Im not going anywhere. I just had to put the RC stuff on hold for a bit.

cyrrus

iTrader: (5)

jason thanks for chiming in.I guess i might need to place racing on hold for another year.

chris moore

iTrader: (96)

Thats good to hear Jason.

powerpark2

Jason when you get time. I need a few parts (pivot ball) for my copperhead 12 scale front end.
Thanks,
Joe

chris moore

iTrader: (96)

If anyone that ran the copperhead has any parts left over shoot me a pm, in need of a few things.

pmes

iTrader: (3)

I will happily sell my car (it has the new front end) and all the parts I have, many of which are NIP. I'm not sure how much to charge, and I'm at work so I can't get you the details of what I have until later. If you want I can also check with my LHS as they carried parts just for me and I they have some left.

What all do you need?

chris moore

iTrader: (96)

PM sent