ProtoForm Mazda 6 Body
#31
Club carpet race on foam tires(purple/orange, purple) with a monster stock. 25.92 rollout.
I cut the wing to the smaller lines and didn't use the wing dividers. The roof of the body is about 1cm lower then roar rules require and the wing its about .5cm higher then roar max. The wing doesn't stickout to far off the rear, about .5cm below the roar max. It's for club racing and I don't run big races so it's not a big problem for me.
I cut the wing to the smaller lines and didn't use the wing dividers. The roof of the body is about 1cm lower then roar rules require and the wing its about .5cm higher then roar max. The wing doesn't stickout to far off the rear, about .5cm below the roar max. It's for club racing and I don't run big races so it's not a big problem for me.
Last edited by fatdoggy; 04-03-2004 at 09:57 PM.