Conrad

iTrader: (3)

On the subject of the foam car are the top link positions any lower that on the standard EC towers? Or are they just the same minus the 2mm riser plates under the diffs, just wondering....

King-G

the alloy block markings are a little confusing as they are a legacy part from the offroad car. You must install them as Bob suggested, with the letters facing downward, and the rounded sides facing away from the centre of the chassis.

also make sure the hole for the hingepin is at the top side of the block.

King-G

Please note everyone: when building the kit from new
please dissasemble your CVD's lube them and use loctite on the grubscrew. If you havent yet done this please go back and do it.

They dont come lubricated, and the locking grubscrews aren't tight enough, causing the pins to work their way out.

bob33

yeah i fount that out lol broke 3 pins in them in 1 run sorted now tho

AdrianM

iTrader: (4)

The inner camber links are higher on the Foam spec toers than on the EC tower. This compensates for the lower drive train and lowered hinge pins.

Roberto Falcon

iTrader: (18)

How much is this new kit ?

Marcos.J

iTrader: (239)

I think is 419.99

cornerspeed

I did this on my initial build and no problems there. It definatly needs it.

cornerspeed

Here's the pics of my MI2EC rubber tire car.

Jon Kerr

iTrader: (17)

I forgot you've got the alloy rear body mounts. You have a part number for those?

DirtyDog3375

iTrader: (37)

Just finished building and wiring up my EC!

Can't wait to get it out on the track.....for some valuable practice and testing!!!

Sorry about the lousy photo (battery went dead in the digi!)

bender

iTrader: (4)

OMG

What happened to the Losi? How will you be Pete's buddy now

And where's the brushless eh?

Lenny, at least your still living up to your old nickname

DirtyDog3375

iTrader: (37)

OMG

What happened to the Losi? How will you be Pete's buddy now
It's only a car, he will cope.

And where's the brushless eh?
Didn't want to depart with it. I had to compromise the way I drive too much, so it's gooooneeeeee!

Lenny, at least your still living up to your old nickname
Sticks and stones will break my bones, but names will never hurt me!!!

heavy

iTrader: (23)

Probably depends what car Pete is going to be driving

bob33

bit of help please. racing at don valley its on a weird flooring (indoors runing track) but i usehky have grip. anyway firsttime out with the ec and it was a pig . got it beter by the final but bit late then. i started with the std kit set up and then my final set up was:

remove the 1mm spacers from the front pivot bloks (on risers)
swap the rear 2mm spacer to a 1mm
put a .5mm ontop of the 1mm spacer of the front rear block (forgot the real name)
front spring changed to red (to try and get sum rear end grip)
front silver role bar no rear.
camber 1 front 1.5 rear
droop as teemu (std kit)

anythink els u need ?
runing vetec tyres (control)

i just need some all round grip realy can any one help me?