aus jd 2703

iTrader: (5)

darkseide ide wrap your bulk head in electrical tape. just piece of mind sure the aluminium is annodized but it doesnt take much to scratch it off then u have a short.
just an idea

skypilot

iTrader: (14)

question, when i run brushless with 5 cell, the car is amazing, i don't add weight to make up for the missing cell or imbalance of the chassis. when running lipo, if not mandated by the track why would you add weight. is it that much of difference that if effect handling in a different way? thanks in advance

Darkseid

iTrader: (9)

Its hard to see in the pics, but theres actually not anything near any of the aluminum to short. The positive lead looks close in the pics, but its actually quite far under the bulkhead. And it can't move up because the wire is squeezed slightly under the bulkhead, so the wire can't move at all. The picture makes it look MUCH closer than it actually is. But I couldn't think of a better angle to shoot from.

Believe me, I went over it with a fine tooth comb. I spend almost as much time wiring as I do building my cars(and unfortunately...I'm not exaggerating ), so once I settle on a layout, you can be sure that everything is safe.

abailey21

iTrader: (37)

gimmie till tomorrow morning when i get back to the office, i think its something like g330??

Darkseid

iTrader: (9)

No problem...

Darkseid

iTrader: (9)

Hey, I think I found it...for once I had some luck with the SchuUSA search engine.



Part#G315

So hopefully next time I take a pic of my Mi3, I'll have the proper towel so that Randy will be a little more at ease.

skypilot

iTrader: (14)

my next order will start with that. save one for seattle adam.

Static_racing

Most of us were running those caster blocks, Contact Mr. McGoo

abailey21

iTrader: (37)

have Marc crap a few my way too

abailey21

iTrader: (37)

thats the one, it is red though, not gray hope thats ok

dawgmeat

iTrader: (9)

Bullsh!t I asked first

Mr. McGoo

iTrader: (23)

i will have a list of what is left of Tamale's c-hubs tomorrow....I will be shooting a pm to those that have contacted me already....

mm

JayBee

iTrader: (31)

Check yo PM's brah...

Nexus

iTrader: (42)

1. I thought I saw some IIC pics and guys had red Schumacher pit towels? I know about the blue but is there a red?

2. Running a spool...if the back end is a bit loose midcorner then on power what would you change. I realize you don't have the full setup but just wondering what some of you might do.


Ran the car finally on carpet w/spool, 13.5 BL, rubbers tires. It's super smooth but wanders out a little when driving hard midcorner. It was fast and in the main I had the fastest lap. Just want to clean up the midcorner drifting...

Thanks in advance.

Randy Caster

iTrader: (47)

haha, that was Numan that noticed it, just figured I had to post his remark lol