150mm micro body
I know there are only few 150mm micro bodies, but which body is the best amount of avaliable bodies?
|
BMW;)
|
Are you asking which is the best 150mm body for racing, Aku-Man? If so, then I'd recommend the HPI Corvette, & I also like ProLine's Ferrari F360 Modena(work fine with the HPI molded wing on it).....:D
|
Are you asking which is the best 150mm body for racing, Aku-Man? |
I think Corvette is the best avb body for racing.;)
|
BMW |
But Corvette is damn ugly for real car and rc. To me.:sweat:
|
Well the Bimmers did handle pretty well here locally. They are in my opinion better for tight turns compare to Corvettes that is better for open track. Its a matter of how the driver drive and how the setup matched the track. ;)
|
All of the 150MM RAD bodies are very good handling. Look them up at http://www.microrcshop.com. I used the DTM.
|
How about PTI Nissan R390?
|
150 mm bodies
ARM's Toyota and Porsche GT bodies are the best for racing... imho.
J |
I like that toyota GT. Who have it in stock?
|
www.atlashobbies.com has a good selection.
|
But the toyota gt is a 140mm body guys. U are forgetting. How about tryin the Nissan Skyline? That's wat i use.
|
The Skyline's ok, but it's not as wide as I'd like. That's what my first micro came with, & while it was decent, I still think that the 'Vette handles better. And as I said, I've also been using the Ferrari 360 Modena shell that came with my new XRay M-18, & I really like that one too(but since it's on a different chassis, it's hard to make a direct comparison).......;)
|
All times are GMT -7. It is currently 08:06 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.