charging Li-Fe 6.6v reciver pack 1/12 ??
#1
charging Li-Fe 6.6v reciver pack 1/12 ??
I did buy a Li-Fe 6.6v 200mah reciever pack for 1s li-po in 1/12. I have problem with chargin the pack, does anyone now how to charge Li-Fe ?? I do have a choice in charger menu for li-fe 3.3v / cell . I try to charge 0.2 amp in 2cell 6.6v but do get error mess: high voltage overload
#2
I did buy a Li-Fe 6.6v 200mah reciever pack for 1s li-po in 1/12. I have problem with chargin the pack, does anyone now how to charge Li-Fe ?? I do have a choice in charger menu for li-fe 3.3v / cell . I try to charge 0.2 amp in 2cell 6.6v but do get error mess: high voltage overload
#4
Tech Adept
make sure you set your charger to charge at 2s mode (6.6 = 2 cells in series).
#5
charger
i use this charger: GT POWER GTP-A6-10
#6
It could be your charger. Do you have another charger or a friends charger you could try?
#7
Tech Apprentice
Where can one find these LiFe receiver packs for 1/12th. I suppose it works well without any regulator?
#8
#9
li-fe
i think i found the problem !! the li-fe cells did have 7.6v so when i start charging the volt is to high. I did discharge for a while to get less volt then it did work !!! i did buy mine at rc-mushroom.com, search for 6.6v, $15 each