Xray T1
Tech Master
iTrader: (1)
Anyone have an asphalt setup for the FK?
This is my first time outside (all carpet before) and a starting point would really help
This is my first time outside (all carpet before) and a starting point would really help
NVisible you got pm
Tech Master
iTrader: (1)
STRIKER, thanks a lot!
Anyone have a good gear setup for a Quad mag motor with 2.125 internals on large track?
I never ran one of these motors and I don't want to burn it up.
Thanks
I never ran one of these motors and I don't want to burn it up.
Thanks
Tech Master
iTrader: (104)
I just bought a used evo and wondered if I could put a FK04 chassis on the car? I am thinkin of ordering the BMI chassis but do not know if it is compatible.
It already has the shortened arms and c hub set up on it with the lower ratio pulley.
Here is the pics of the car... Thanks for your help
It already has the shortened arms and c hub set up on it with the lower ratio pulley.
Here is the pics of the car... Thanks for your help
Tech Master
iTrader: (1)
yep, should fit. the evo2 and FK chassis are the same
Tech Addict
iTrader: (2)
alright guys i have t1fk, what should i do to make it better. thinker chassis different shocks etc. give me some input.
Where do you race? carpet or asphalt?
Tech Addict
iTrader: (2)
high bit carpet
you need a carpet setup I'm sure someone on here can help you.
I race outdoor on asphalt.
I race outdoor on asphalt.
Tech Addict
iTrader: (2)
thanks deves
Tech Master
iTrader: (1)
if you want another chassis you can get the XRC chassis or go the BMI route and get either the split or the .350
as for setup, theres some at www.teamxray.com you just have to search for Factory Kit and then the downloads section
as for setup, theres some at www.teamxray.com you just have to search for Factory Kit and then the downloads section
Guys.... I need your advice :
My T1FK is very slow during mid corner entry. Even tamiya TT-01 with silver can is able to match the entry cornering speed
If I enter corner too fast, the car have tendency to go wide losing my racing line.
If I immediately push the gas ( don't let the car behind me to pass ) the car could easily spin.
I need more speed at every corner entrance.
What necessary tips should I consider ? Just give me the tips and I'll check the possibilities of each tips. Thanks guys.
My T1FK is very slow during mid corner entry. Even tamiya TT-01 with silver can is able to match the entry cornering speed
If I enter corner too fast, the car have tendency to go wide losing my racing line.
If I immediately push the gas ( don't let the car behind me to pass ) the car could easily spin.
I need more speed at every corner entrance.
What necessary tips should I consider ? Just give me the tips and I'll check the possibilities of each tips. Thanks guys.
sorry, double post.