nube.. quick advise plz
#1
nube.. quick advise plz
would a vxl or sidewinder be ok to run in a car. or should i just get a novak havoc
#2
Depends on what you want to do with it. Race or just bash?
#3
i would pick the havoc system.... its sinsored so its better for racing
Alex
Alex
#4
race at my local track
#5
y would sincored be better wuts it do again??
#6
#8
i would be new to brushless. but not racing i race everyweek
#9
I'd take a closer look at a Tekin system. I know they are expensive, but they are the cream of the crop right now. I looked at the Havoc systems when I was first going brushless, but they didn't stack up very well against the competetion as far as features goes. The Losi can handle lower turn motors and has a higher peak current rating then the Havoc.
The Xcelorin systems from Losi are better and can be had for the same price as the Havoc. I have a 13.5 system for sale actually. It is in the for sale forum. It's pretty new only about 8 hours use on it. I'm asking $150.
The Xcelorin systems from Losi are better and can be had for the same price as the Havoc. I have a 13.5 system for sale actually. It is in the for sale forum. It's pretty new only about 8 hours use on it. I'm asking $150.
#10
Company Representative
Novak Havoc Information
Here is the current listing of the affordable, Novak series of Havoc Sensored Brushless Systems
~ Havoc 2S Sport System with 8.5 (5000Kv) motor $139.99
~ Havoc 2S Spec Systems with (ROAR-approved) SS Pro 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) or 21.5 (1800Kv) motors $149.99
~ Havoc 1S Systems with (ROAR-approved) SS Pro 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) motors $159.99 (shipping in October)
~ Havoc 3S/Ballistic 8.5 (5000Kv) (ROAR-approved) motor $164.99
~ Havoc Pro 2S Systems with (ROAR-approved) Ballistic 3.5 (10500Kv), 6.5 (6400Kv), 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) $194.99 (shipping in September)
[We will probably add an additional Havoc 1S controller with the cooling plate installed (rather than the HS).]
~ Havoc 2S Sport System with 8.5 (5000Kv) motor $139.99
~ Havoc 2S Spec Systems with (ROAR-approved) SS Pro 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) or 21.5 (1800Kv) motors $149.99
~ Havoc 1S Systems with (ROAR-approved) SS Pro 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) motors $159.99 (shipping in October)
~ Havoc 3S/Ballistic 8.5 (5000Kv) (ROAR-approved) motor $164.99
~ Havoc Pro 2S Systems with (ROAR-approved) Ballistic 3.5 (10500Kv), 6.5 (6400Kv), 10.5 (4200Kv), 13.5 (3300Kv), 17.5 (2200Kv) $194.99 (shipping in September)
[We will probably add an additional Havoc 1S controller with the cooling plate installed (rather than the HS).]
-----------------------
More Havoc on-board programming options than most racers need.
On-board, user-friendly interface with nine adjustable parameters:
~Minimum Brake (10 settings from 0-27%)
~Drag Brake (10 settings from 0-27%)
~Dead Band (5 settings from 2-6%)
~Minimum Drive (5 settings from 1-5%)
~Throttle Curve (Linear and Expo)
~Brake Frequency (7 settings from 1-8 kHz)
~Reverse
~Motor Rotation
~Li-Po Cut-Off via Novak’s One-Touch™ button
~Minimum Brake (10 settings from 0-27%)
~Drag Brake (10 settings from 0-27%)
~Dead Band (5 settings from 2-6%)
~Minimum Drive (5 settings from 1-5%)
~Throttle Curve (Linear and Expo)
~Brake Frequency (7 settings from 1-8 kHz)
~Reverse
~Motor Rotation
~Li-Po Cut-Off via Novak’s One-Touch™ button