KO PROPO EX-10 Helios q's
#2013
Is it possible to replace the wheel on the KO?
Id LOVE to get the same sheel on the C2.......
http://www.shopatron.com/img/product...1_KPP80231.jpg
Id LOVE to get the same sheel on the C2.......
http://www.shopatron.com/img/product...1_KPP80231.jpg
#2014
ehh, its a lil mixed up lol
but yes it does it looks like
but yes it does it looks like
#2018
Tech Lord
iTrader: (26)
Budman, there is no external adjustments on the trigger tension. What i did to my helios was to open up the radio and replace the spring. i took the spring from a clickable pen, cut it down to length, and installed it. it made the trigger tension a lot higher (stiffer) which made it a lot better for me. have a couple of spare springs in your toolbox though, doing this modification, the spring broke on me during a race and i had to replace it.
#2020
Tech Master
iTrader: (22)
Thanks I will give it a try!!!!!!
It felt a little soft to me.
It felt a little soft to me.
Budman, there is no external adjustments on the trigger tension. What i did to my helios was to open up the radio and replace the spring. i took the spring from a clickable pen, cut it down to length, and installed it. it made the trigger tension a lot higher (stiffer) which made it a lot better for me. have a couple of spare springs in your toolbox though, doing this modification, the spring broke on me during a race and i had to replace it.
#2021
im not shre is this has been asked allready but can you run two throttle/ break servos on the heilos without using a splitter
like on my spektrum radio you could have one servo by pulling the throttle and another servo by using the break and while one is being used the other one stays at centre
help?
like on my spektrum radio you could have one servo by pulling the throttle and another servo by using the break and while one is being used the other one stays at centre
help?
#2022
Tech Apprentice
Yes, you can use either in the EX-10.
#2023
Tech Apprentice
#2024
When will the 2.4 gig module/receiver be released ?
Thanks.
Thanks.
#2025
Tech Apprentice
like on my spektrum radio you could have one servo by pulling the throttle and another servo by using the break and while one is being used the other one stays at centre
You may set up the third channel to operate a serperate servo.
Please refer to page 57 in your manual for the details.
You may set up the third channel to operate a serperate servo.
Please refer to page 57 in your manual for the details.