Originally Posted by Pro10noob
Perhaps it is asked before but it is early and about to go to work.
Who is doing a decalset of the Mercedes W01?
If so on what body is it based?
The F60 or the Mclaren?
A Chevron F-110 Body could be good for the job, too. You could get the needed decals and body at ddrive.
Originally Posted by 2-Bad
The tire selection & balance is the most important, the next is the diff tension. It's a pain to adjust as it's got to be done on the track, but once set correctly you will gain max grip from ur rear tires.
Damn right :-D
I have a similar setup. Works good on carpet:
Front: (everything kit set except)
Toe: 2.0 deg out
Spring - black (hard)
Ride Height - 3.5mm
Rear: (everything kit set except)
T-plate Tension - 1xO-ring & very loose
T-plate Type - High Traction plate
Friction Plate Lube - none
Friction Plate - F104Pro stock
Friction Plate Tension - 3 mm
Shock Oil - tamiya red #200 shock oil
Shock Spring - F104Pro stock
Ride Height - 4mm
Axle - carbon
Diff Grease - associated stealth (black writing on tube)
Diff Tension - as loose as possible without slipping. (Critical setting)
Esc - Speed Passion Club Race
Servo - Sanwa SDX-801
Motor - GM 13.5T
Battery - LRP 4000 LiPo
Tires - Tamiya foam (front hard, rear f103 hbr soft)
Ambient - 22 deg Celsius
Track - carpet, technical.