The Speed Passion Thread
#4323
17.5 expert race results, another tq and win for sp, the only car with SP esc and motor, (so far )
http://fantasyworldracing.com/index....=111&Itemid=58
tried a couple different setting, actually lowering the throttle delay and rpm delay it went faster and ran cooler, still working on the magic gear ratio/esc setup. its only going to get better
http://fantasyworldracing.com/index....=111&Itemid=58
tried a couple different setting, actually lowering the throttle delay and rpm delay it went faster and ran cooler, still working on the magic gear ratio/esc setup. its only going to get better
#4324
#4325
Tech Master
iTrader: (83)
17.5 expert race results, another tq and win for sp, the only car with SP esc and motor, (so far )
http://fantasyworldracing.com/index....=111&Itemid=58
tried a couple different setting, actually lowering the throttle delay and rpm delay it went faster and ran cooler, still working on the magic gear ratio/esc setup. its only going to get better
http://fantasyworldracing.com/index....=111&Itemid=58
tried a couple different setting, actually lowering the throttle delay and rpm delay it went faster and ran cooler, still working on the magic gear ratio/esc setup. its only going to get better
#4326
would suggest putting the esc on as it will have more power. I noticed that when the switch is off the led on the esc is not as bright as when its switched on. This to me says that the voltage is not what it should be.
#4328
Tech Fanatic
iTrader: (23)
Join Date: Dec 2003
Location: Has there ever been a race won on RCTech?
Posts: 959
Trader Rating: 23 (100%+)
Neutral range is the amount of "play" in the trigger. So the larger the number the more you have to pull the trigger to get the car to go forward or operate the brakes. It doesn't change the cars performance as much as the performance of your radio as a interface to the car. Check out the included picture for clarification.
-j
-j
#4330
Quick question guys please.
What size are the connectors used on the SP V3 motors?
What size are the connectors used on the SP V3 motors?
#4333
Tech Apprentice
Hi guys, I'm set to try the 422 software down my club on Friday with v3 10.5
the track has a 20m straight and i was hoping someone has tried it with success..what are the main settings to play with? I don't want it too punchy on the infield but would like to rip down the short straight
cheers mark
the track has a 20m straight and i was hoping someone has tried it with success..what are the main settings to play with? I don't want it too punchy on the infield but would like to rip down the short straight
cheers mark