kwiksi

iTrader: (125)

Guys
Going to try my hand at rubber tc. I will be running stock 528 w/ SP 17.5 v3 on a small/med size track with a 90ft straight. Any idea on starting point for gearing? I'm an offroad guy so...this is all new to me.

skypilot

iTrader: (14)

I would tell ya, but being the ex-red headed step child of Team speedpassion I will just be corrected.. there are setups on the speedpassion web site but I would wait for marcos or charlie b to post a setup

Racecrafter

iTrader: (25)

Start around 5.0FDR depending on SC timing.

mr crum

iTrader: (5)

if your running newer s/w with alot of boost and punch i would start at 6.0fdr

dirtracer20

iTrader: (24)

Question I have the gt2 my program box broke when it hit the floor,will the program box from the citrix system work on the gt2 I've tried to put reverse in with the box no luck

mr crum

iTrader: (5)

i think it will work i will try it in the morning let you know

IgorR

Does anybody have a good setup for a GT 2.0 on carpet with a 10.5T?
What gearing are you using?

Thanks

cherry2blost

iTrader: (1)

Oh poor Blossom bloody bullies

kwiksi

iTrader: (125)

Just found out no boost allowed so I will do Zero timing. Any suggestions on start gearing? What about timing on the actual motors endbell?

abailey21

iTrader: (37)

Oh Ritchie you rascal!

Korey Harbke

iTrader: (13)

No timing 17.5? 4.0 final drive is always a solid starting point on the track size you describe. You might gear up a tooth, but its a good starter point. Which motor are you using?

Hope that helps!

-Korey

skypilot

iTrader: (14)

hey adam. miss you.

abailey21

iTrader: (37)

That makes me warm inside

this makes me lol hard

Danny-b23

iTrader: (3)

I generally run maxed endbell timing, no matter what the track size, but my gearing ranges anywhere from 3.7-4.2 FDR.

mr crum

iTrader: (5)

your on the money danny