T.O.P. Racing "Photon" 1/10 EP Touring Car
#7384
How does adding shims to the camber links affect handling?
#7385
It's probably old news, but I see that Mike at Exotek is working on a narrow lipo chassis for the Photon.
#7387
R/C Tech Elite Member
iTrader: (28)
They change the roll center. Shims can go either at the bulkhead or hubs. Please consult a setup book on the effect of the changes and just "play" with it.. as that is the only way to learn.
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
#7388
Tech Elite
iTrader: (24)
They change the roll center. Shims can go either at the bulkhead or hubs. Please consult a setup book on the effect of the changes and just "play" with it.. as that is the only way to learn.
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
#7389
Tech Addict
anyone know a way to add bump steer ? normally with the links to the steering arms underneath we'd add shims...
#7394
They change the roll center. Shims can go either at the bulkhead or hubs. Please consult a setup book on the effect of the changes and just "play" with it.. as that is the only way to learn.
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
The fact that you can use shims at the bulkhead is one of the reasons I like the Photon as compared to my previous TC (Xray).. but even they have seen the light too -- it will just cost a small fortune to m
ake that upgrade
Here is what I think I know.
Shortening the links increases camber gain.
Lenthening descreases camber gain.
Lowering the inside position increases camber gain.
Raising the inside position decreases camber gain.
Raising the outside position decreases camber gain.
Lowering the outside position increases the camber gain.
I'm not sure how roll center is affected.
Also, keeping the camber rods the same length, how does moving them from the inside position to the outside position affect camber gain and roll center. This is only adjustable in the rear.
#7395
I tried u-pro spool...
delrin cup, after only ONE race, have a little break...
there are steel cup, compatible with u-pro spool?
delrin cup, after only ONE race, have a little break...
there are steel cup, compatible with u-pro spool?