T.O.P. Racing "Photon" 1/10 EP Touring Car
#5311
Hi Guys
How do you measure rear droop with that rear upright has a bridge under
do you usually remove rear upright And Measure it ? (Xray method :measure under the rear wishbone) or do you add certain amount on top of the reading ?
Thanx
How do you measure rear droop with that rear upright has a bridge under
do you usually remove rear upright And Measure it ? (Xray method :measure under the rear wishbone) or do you add certain amount on top of the reading ?
Thanx
#5314
so If I want to match to my xray setup Its ok to remove the rear hub and measure ...
#5316
There is a little flat on the outside edge of the wishbone, allows me to use the normal droop gauges that most people are already used to. Nice and easy
#5317
Tech Elite
iTrader: (20)
Join Date: Sep 2001
Location: MEMBER OF THE "MWC" Mimi Wong Clan
Posts: 2,442
Trader Rating: 20 (100%+)
Hey guys.. anyone selling a Stock LIPO chassis thats clean? (this is the one that comes with the new kit) lmk...
thanks!!
thanks!!
#5320
I go off the connector piece that hangs down. I run anywhere between .5 to 1.5.
#5321
I have problem With Rear Toe-in
i have 1mm RF an 3mm RR
but
on Setup Gauge Station
SX is 2° DX 3.2°
Car is New, NO Yoke no Crash
Help me
i have 1mm RF an 3mm RR
but
on Setup Gauge Station
SX is 2° DX 3.2°
Car is New, NO Yoke no Crash
Help me
#5323
you know those two Red O Rings comes with Gear Diff we use them as a spacer on both side before installing the ballbearings is that right?
Cheers
Cheers
#5324
#5325
Yups
Looking for some setup ideas now
do you use top bladders or Tamiya ones? or should I go for Tamiya shocks
Looking for some setup ideas now
do you use top bladders or Tamiya ones? or should I go for Tamiya shocks