stiltskin

iTrader: (103)

Good weekend with the car. Started with a push and made some changes throughout the day to make the car turn better. TQ'ed during round 1 and then stepped it up in round two knocking 5 seconds off my time. Made some bad changes to the speedo in round 3 and pulled it off the track after 3 laps. After taking a few bumps and bruises on lap 1 of the main, I fell back to 5th. Quickly worked back through traffic and took over the lead with about 2 minutes left. We had a great battle, swapping positions on about every lap. Fell to second with less than 30 seconds on the clock and ended the race just a couple 1/10s out. Probably the most fun I've had on the track in awhile.

(Congrats DaveW)

sammies

iTrader: (1)

Hi,

Can you share what you did to tweak your car so that it pushes less?

I am experiencing understeer from mid to exit of the corner, and its really frustrating...

thanks

sam

stiltskin

iTrader: (103)

Started with EJs South Africa setup. Changed roll centers to medium high and shorted the rear wheel base. Made a couple droop adjustments and finished the day. I still think there's more in the car but it got better through the day. Solaris Hard tires were running good all day long.

Goingfast

iTrader: (29)

where did you get the EJ set up or where is posted?

mikel33

iTrader: (2)

page 293.

Goingfast

iTrader: (29)

Thanks

pcar951

iTrader: (23)

I just bought a New Photon special edition kit. Wondering if you all can give me some ideas what I'll need for spare parts and tuning stuff. I'll be running rubber tire on carpet only, I'm an experienced racer.

thanks for any help

Rod M

iTrader: (4)

out of the box I would:
replace the front alloy dogbones for steel ones,
and use a servo saver, otherwise you will break the bell crank with a big hit,

Rod M

iTrader: (4)

this is three years old from the Scythe

some drivers in Aus have made this fit in the photon with some shims.

008-Racer

Hi can anybody please tell me what ball nuts and studs this gentleman is using to mount his shocks and camber links

Also what anti roll bar mounts are these?

Goingfast

iTrader: (29)

it is hard to tell,first of all what shock is this guy is using?
From the pic .it look like tamiya threaded ball cup studs

RC MARKET

iTrader: (12)

yes i'm think same is tamiya shock !

pcar951

iTrader: (23)

46mm steel shafts?

Ron Goetter

iTrader: (17)

Why would anyone what to do that? The rod ends on the photon are the best out IMO...

kschu

iTrader: (16)

available soon....