JDM_DOHC_SiR

iTrader: (31)

Looks nice.... glad to have ya on board

-Dave

Turbonium

iTrader: (27)

yea, i wasnt in that room up front that much. my friends Derek and Jay were right behind ya. i did remember that you had a few issues, prolly some due to parts availability.

Turbonium

iTrader: (27)

ill second that! congrats on the new purchase, and good luck with it!

=MisFitz= NuKe

thanks guys, dave you have already helped me a bunch with it, lol . I will be racing it at the nats and hope to do well with it in 19turn, and if I can afford it, mod.

JDM_DOHC_SiR

iTrader: (31)

Your welcome
-Dave

racer

can anyone help me out here?

if i remember correctly, someone on the forum mentioned the stock kit comes with 4 degrees of castor.

how do you get an 8 degree castor? is there an 8 degree block out there?

any help would be appreciated.

Thanks!

racer

JDM_DOHC_SiR,

see that your going to get your hands on the Evo IV. let us know how the testing goes

JDM_DOHC_SiR

iTrader: (31)

I wil 2 weeks from now I`ll be putting it together and posting out my findings with settings and such
-Dave

=MisFitz= NuKe

hey Dave,
you see the thing in the one-way vs. spool thread, the note that Adrian Martinez wrote. What do you think about spools in the 415, you think I should get my hands on a spool, and try to make a solid center shaft for the nats?
Also, the money is being sent out today, hopefully I will get those parts in time for the nats. Also, can you get a solid center pulley?
Thanks,
Mike

Turbonium

iTrader: (27)

mike, not sure about the spool, but tamiya is releasing a locked 1-piece center pulley. here is the info:

Item 53708 TRF415 Direct Center Pulley

not sure of the availability yet... i have modified the stock center using an extra locked pulley, as a lot of others have.

Martin Crisp

Hi racer.

I don't know the part number, but the 8 degree was the original caster block for the TA04. They should still be avail.

racer

Thanks, for your help.

oh, and regarding your one-way setup.

would it work with a stock motor as well?

Thanks again

Fully Hopped

Hi,
Does any 1 have a list of the screw sizes and how many I would need to upgrade to TI.

Thanks

Paul_Kultcha

Someone posted a few pages back that the TA04 blocks - the 8 degree blocks - where actually the same as the stock TRF415 blocks. The difference in Castor comes in the amount built into the chassis mounted toe blocks and the spacers underneath (amount of anti-squat).

=MisFitz= NuKe

there is enough room to fit a second locked pulley? I am not seeing it, or are you modifying the second pulley to fit in the same amount of space the one way did? Also, are you grinding a flat spot on the shaft for the set-screw?
-Mike