Tamiya TB-Evolution II
#601
Tech Master
will the real surikarn please stand up!lol,i definatly no this is not surikarn or as we no him!
#603
Tech Master
i know he drove the 414 wen the evo2 was out.
mark reinhard drove the evo2.5.
a evo 2 with 04r suspension arms.
mark reinhard drove the evo2.5.
a evo 2 with 04r suspension arms.
#604
Cross Spur Gear Adapter for TB Evo II
hi guys
i would just like to no were i can get a Cross Spur Gear Adapter for TB Evo II and how much in Australia
thanks
i would just like to no were i can get a Cross Spur Gear Adapter for TB Evo II and how much in Australia
thanks
#605
Check Your PM I have one if you want to buy it.
Steevo
Steevo
#606
Originally posted by Motorsports00
hey guys,
what would you recommend as a good all round pinion gear for a CORE 10x2? just something to work off????
hey guys,
what would you recommend as a good all round pinion gear for a CORE 10x2? just something to work off????
cheers n beers
will
#607
Tech Master
hey guys,
what would you recommend as a good all round pinion gear for a CORE 10x2? just something to work off????
thanks
will
try a overall ratio of around 7;0.
what would you recommend as a good all round pinion gear for a CORE 10x2? just something to work off????
thanks
will
try a overall ratio of around 7;0.
#608
TRF race. thanks... bu it means?? wat pinion with a 88 toother..??
thanks
thanks
#609
Tech Master
try about a 36-37.
#610
thats good for stock.. but i think 10x2 would be set for maybe 29/ 30?? wat do others think??
thanks again
thanks again
#611
Tech Master
itll b slow down the straight low.
#612
TRF racer.. thanks for your advice.
will.
will.
#613
Tech Initiate
bevel gear stripping
Greetings fellow evo 2tian's,
I have just received my tamiya evo2
and i must say i am very impressed with the car's looks and handling. unfortunately for my past two outings, it seems like my rear bevel gear is stripping. Has anyone of you ever experience this, if so please advice. I'm at my wits how to solve this problem.
Thank you very much in advance.
Daren
I have just received my tamiya evo2
and i must say i am very impressed with the car's looks and handling. unfortunately for my past two outings, it seems like my rear bevel gear is stripping. Has anyone of you ever experience this, if so please advice. I'm at my wits how to solve this problem.
Thank you very much in advance.
Daren
#614
Tech Master
ive never stripped my bevel gears and that was including my 8 double.
try some new ones they might just be a weak manufacturering fault.
are you sure its stripping?
try some new ones they might just be a weak manufacturering fault.
are you sure its stripping?
#615
Tech Initiate
Bevel deformity
Thanks for your reply TRF racer, but it's not exactly stripping but the bevel gear becomes deform. This results in improper meshing between it and the big gear on the ball diff. I'm using a 10T double and running it on full time 4WD. When this phenomenon occurs, usually there will be a grinding noise at the rear gearbox and the car turns into a front wheel drive. Could it be my hard braking at the corners? Thanks again