disaster999

iTrader: (1)

ignore the mis matching battery tray, i lost one got a replacement in the mail. had to make something up for the time being so i can kill some time on sundays

jonny123

very nice mate
keep the pics coming guys

tc3team

You can tell the passion for r/c some guys have here with the time they've put into their cars.

Just don't put them into the boards guys...

Insert top brand Chassis /ESC / Motor etc etc here $$$$$.....

That horrible feeling of seeing a brand new chassis/shell/whatever going into the board... Priceless.

For everything else, there's Mastercard

Dark_gouki

iTrader: (31)

Hebiki

iTrader: (26)

where can i purchase a crimping tool and new connectors? thanks!

this is a very motivating thread when i look at my wiring and it looks like the wires you see in the movie Alien.

KHoff7

iTrader: (5)

I personally don't crimp just solder the little connector on and clip it into the plastic housing.

I use these:
http://www.nexusracing.com/product_i...oducts_id=1657
Those are out of stock but they have the futaba ones in stock with the little tab.

Hebiki

iTrader: (26)

sweeeeeeet! thanks dude.

Mark506

iTrader: (42)

This was hard, because all the wires were all full length, so you had to find a place to hide them.

CraigM

iTrader: (34)

Just about done. I need to get a marker to black out the wires, and I need to mod my transponder wires and mount it. Can someone tell me how the transponder case comes apart?

act2007

iTrader: (46)

A lot of nice cars in here! Here's mine before it goes for sale!

adam lancia

iTrader: (2)

You're better off with black shrink around the PT wires. The case gets destroyed when you take it apart because AMB fills it with epoxy then closes it up so it's all glued together in there.

act2007

iTrader: (46)

Thanks for the advise, I know what you mean. I just got lazy to put my
black shrink wrap over the PT wires!

CraigM

iTrader: (34)

thanks! I've curled them for now, I'll grab some pins from nexus for shortening them

jonny123

Wow thats very nice. You have so much space to play with tho. The electrics on mine are neet but are very close together. What reciever is that ? I have a novak 13.5 and the sensor lead snapped at the speedo end. SOO i had to cut the sensor wire and solder another bit of sensor lead to it. It was very time consuming but i did it. And i shortened it at the same time. Just gets rid of some of that unwanted sensor lead.

jonny123

Is that the sticky tape showing in between the esc and reciever.