Xray M18
#721
I'm planning to get the M18 kit but I want to use the Spectrum receiver because I want to use my M11 radio. Does this car has spece for it
#722
Super Moderator
iTrader: (2)
Sort of, but it depends on what servo & ESC you plan to use. I've made one fit with a proper micro servo(like the size of a Hitec HS-81, for example) & a Novak Spy for the ESC, but anything bigger & I'm not sure. In the end, you might just have to try placing it on top of the servo(which is what I'm doing now with the Motek Panther chassis I'm using, & I have to put the Spy on the upper deck, so the motor plate has room to accomodate any motor & be adjusted properly)....
#723
Yes, there will be space. Futaba 3101 is one of the best choices for servo. Put the rx on edge, between the servo & motor. Esc next to motor. Be carefull with balance. If you use LiPo batteries, you may have to put either the rx or esc on the battery side. Try to get everything on the lower chassis if possible.
#724
Thank you guys for the help, I think I'll get the Mamba brushless motor for my M18.
#725
Originally Posted by Xyvern
Thank you guys for the help, I think I'll get the Mamba brushless motor for my M18.
I have the Tekin system and think it's a better setup than the Mamba, which I also have. The Tekin has onboard programming (no need for a laptop and cable) and is sealed in a nice plastic case, where the Mamba is shrink-wrapped and the ends are open to the elements. They are both great but if I could only have one..I'd get the Tekin.
#726
also, i have noticed that the mamba controller sometimes "cogs" at low speeds when you hit the gas, causing a studder and then a pipe plant, where the tekin is smoother on the response
#727
Oh yeah, and the Tekin has SOLDER POSTS
#729
There's a forum on here for 18th scale now, check there....
#732
Tech Champion
iTrader: (1)
I'd like to convert my slip on wheels to bolt on like the pro kit. Is it just a matter of buying these, or do I need more:
http://www.amainhobbies.com/product_...-Hex-Adapter-2
http://www.amainhobbies.com/product_...-Hex-Adapter-2
#733