Need help BADLY!!! 3ps radio.....
#1
Tech Regular
Thread Starter
Need help BADLY!!! 3ps radio.....
My 3ps doesnt work at all. I pressed "end" once after I was checking out some stuff on it, and now its STUCK on a screen that just says the voltage, "M1", and "BATT". I tried pressing EVERY button, changing the battery, turning it on and off, etc. What the heck do I do?! I just bought this used from someone and it worked fine for a little bit until I pressed "end". PLEASE help!
#2
Tech Adept
hey if you want to buy another one...i have one!!! pretty cheap with a blue LED in place of the red one. i dont know anything about your problem though...mine has always worked fine. if your interested e-mail me at [email protected]
~Zig
~Zig
#3
Tech Adept
did u try removing the batteries and leaving it off for a while then putting it back on?...
#4
R/C Tech Founder
This normally means that the back-up battery on the 3PS is dead. The only option is to send it to Airtronics for repairs, it needs to be done every 2-3 years.
#5
Tech Regular
Thread Starter
Weeeeeird I think I fixed it. Once I push end, it locks up kind of. But once I push BOTH arrow buttons at the same time it goes back to normal. Now I have other problems:
Every time I plug in my Explorer2 to my Futaba receiver, along with my futaba standard servo the ESC doesnt respond and it doesnt steer. But if I just plug in the esc and no servo it works fine (no steering). I tried a different servo and it works fine ( another futaba servo from another car). How can I fix this, I dont want to have to buy another servo!
Every time I plug in my Explorer2 to my Futaba receiver, along with my futaba standard servo the ESC doesnt respond and it doesnt steer. But if I just plug in the esc and no servo it works fine (no steering). I tried a different servo and it works fine ( another futaba servo from another car). How can I fix this, I dont want to have to buy another servo!
#6
Tech Elite
iTrader: (1)
Originally posted by KevanB
Weeeeeird I think I fixed it. Once I push end, it locks up kind of. But once I push BOTH arrow buttons at the same time it goes back to normal. Now I have other problems:
Every time I plug in my Explorer2 to my Futaba receiver, along with my futaba standard servo the ESC doesnt respond and it doesnt steer. But if I just plug in the esc and no servo it works fine (no steering). I tried a different servo and it works fine ( another futaba servo from another car). How can I fix this, I dont want to have to buy another servo!
Weeeeeird I think I fixed it. Once I push end, it locks up kind of. But once I push BOTH arrow buttons at the same time it goes back to normal. Now I have other problems:
Every time I plug in my Explorer2 to my Futaba receiver, along with my futaba standard servo the ESC doesnt respond and it doesnt steer. But if I just plug in the esc and no servo it works fine (no steering). I tried a different servo and it works fine ( another futaba servo from another car). How can I fix this, I dont want to have to buy another servo!
#7
Tech Regular
Thread Starter
actually Im using a Futaba receiver, and a JRxr2 am transmitter. I plugged them in the right slots, since the throttle works fine. Could it be the servo? I tried it with a different futaba servo and it works fine.
Ill just end up replacing the servo.
Ill just end up replacing the servo.