Awesomatix EP Touring Car (A700 Shaft Drive)
#6752
Tech Fanatic
You can also extend the oval hole of your AM46 on 2.3mm to the front direction, move the bearing ahead and use such modified AM46 with AM54-1.
In case of you use FFG with ball bearing already, such updating should be not so interesting for you IMHO.
New AM43-1, AM44-1, AM42-1 can be used with old AM46+AM54.
#6754
I believe he said he was running Larry/FJ's jackson setup.
#6757
Tech Master
iTrader: (44)
Monti
Good luck tomorrow 80% chance of rain! I am not going to make it.
#6758
Tech Master
iTrader: (46)
No I have not changed anything. I did run Jaco oranges and Sorex 36's and it wasn't any different. I am running the am06m, but I was running those last time too. The only thing I do to my 17.5 car right now is blow the dirt off of it.
Monti
Good luck tomorrow 80% chance of rain! I am not going to make it.
Monti
Good luck tomorrow 80% chance of rain! I am not going to make it.
#6761
#6763
I got to run the new Awesomatix brushless servo today. It is dead nuts accurate, and it was noticeably quicker than the Futaba 9551 I had been running. Once I got used to it, it was almost telepathic. Also seemed like it was held in more solidly since the mount is built into the case. Its pricey, but definitely worth it imo.