Originally Posted by Awesoman
I've just received my alu chassis and directly put it on a my setup board (in fact a glass plate)
It seems like it is not 100% flat. Is this normal or is that a manufacturing error? One side is a liiiiittle bit higher than the other. Will this disappear when the car is built?
And do we still really have to glue the P06-1 to the aluminium chassis?
One side ( left or right) or one end ( front or rear)?
What is the height difference?
Usually the preform has some insignificant curvature in transverse direction.
The final shape of our alloy chassis depends on AM30-1 stiffener correct screwing also.
Please use the glue for P06-1 as you will have to cut the protruding part of P06-1 from the bottom side after installation.