XRAY T2’009
#1051
Jimmy, You got PM.
#1052
People bicker too much on fourms
#1053
Tech Elite
iTrader: (51)
Join Date: Feb 2002
Location: Comin at ya from a distant galaxy
Posts: 2,930
Trader Rating: 51 (100%+)
Hello There Jason
You can use this part it will loosen the tension on the belts. I have the foward motor conversion and use this part with great success heres the part#
302077 - T2'008 Optional Set of Eccentric Composite hubs
Hope This Helps
Mike
You can use this part it will loosen the tension on the belts. I have the foward motor conversion and use this part with great success heres the part#
302077 - T2'008 Optional Set of Eccentric Composite hubs
Hope This Helps
Mike
Hi,
Not sure if it's already been discussed, but I'm struggling with the new 38T Pulley & Forward Motor Position conversion for the 009.
I can't get the belts loose enough either on the Front or Rear. Even with the diff bearing housings adjusted, the belts are still insanely tight
Anyone else had this issue? Any idea's?
Appreciate anyone's idea's,
Cheers,
Jason
Not sure if it's already been discussed, but I'm struggling with the new 38T Pulley & Forward Motor Position conversion for the 009.
I can't get the belts loose enough either on the Front or Rear. Even with the diff bearing housings adjusted, the belts are still insanely tight
Anyone else had this issue? Any idea's?
Appreciate anyone's idea's,
Cheers,
Jason
#1054
#1055
I use the +1 Eccentric hubs in the front with Motor FWD. It sets my tension just right. But they do not work good in the rear for me. The rear belt is either too loose, or a tad tighter than without Eccentric hub in rear. So in other words, I only use them up front.
#1057
Center of holes?
#1058
150mm
#1059
Tech Rookie
setup
does anyone have a setup with t2 oo9 carpet version for asphalt ? thank
you in advance.
you in advance.
#1060
I have a setup question. what are some things you could try to get rid of a hook. I go around the corner and when I get on the gas the car just wants to spin the way I was just turned. It is not really loose. It just wants to keep going in a circle and not straighten up. This is on asphalt.
#1061
I have a setup question. what are some things you could try to get rid of a hook. I go around the corner and when I get on the gas the car just wants to spin the way I was just turned. It is not really loose. It just wants to keep going in a circle and not straighten up. This is on asphalt.
#1062
Tech Initiate
Many thanks to Mike ivy & JimmyMac for your quick responses guys !! This info is a great help and I've just ordered the parts needed.
Cheers,
Jason
Cheers,
Jason
#1063
Tech Champion
iTrader: (208)
Sorry should have read the rest of the later post. This was answered already.
Last edited by dodgeguy; 05-11-2009 at 01:45 PM. Reason: added chart
#1065