firetooth

Chances are this is just a TTL to RS232 circuit based around a MAX232 or similar. This sort of thing is quite common on any microcontroller -> PC connection. I've seen these on PDAs, cable modems, GPS receivers , and so on.

Once again, I have never seen the cable so I'm only guessing and any experimentation is at your own risk.

Merciless

Guys i just sold my NOVAK GT7 to try out the newer 2000j version of this speedo but was it a good move ???

John_S

Id say so!! The vfs is far more tweakable than the gt7 in my opinion that is. Hey guys do you have any good stock/19turn setups you could share with us? Or are the ones from Kos website sufficient enough?

Hebiki

iTrader: (26)

good choice in picking up the VFS-2000j. the "J" leaves a little bit of the battery left so you get some steering just in case your batteries dump, you can steer your car out of trouble.

Hebiki

iTrader: (26)

pick up one of the programs from the Ko site.. those are great starting points that Ko drivers (Hara, Hirosaka, etc) use in their esc's. So you cant go wrong there.

what i did was, i grabbed the stock program and dropped it a few. so my initial throttle punch is increased. i usually have the first four stages at 8.. or even 6 depending on how much punch i want. and i always increase the top end also if there is a long straight away.

KO PROPO Staff

Chris-
It's that pink car again! Curse that car. Going to RCX? If so, see ya there.

Hebiki

iTrader: (26)

DUUUUDE!

where have you been man? racing is not fun when your not around. i might go on saturday.. or go to tamiya. not sure yet. if i get the parts for the 415.. then ill go. most likely i wont get the parts in time tho.. so ill just go to rcx and bother you!

when are u gonna race again? you should join us at the parking lot races man. dont worry about power, ill hook you up.

PizzaDude

When I'm not sure which setup has been put into the VFS, is there a way to go back to the factorysettings?

Francis M.

iTrader: (2)

someone told me the stock settings are 17 all the way through
the power range.

Hebiki

iTrader: (26)

yup

PizzaDude

I was thinking more along the lines of resetting it.
Like f.i. with the GM esc's just holding the button for a few sec's and it's back at the factory settings.

You see, I'm not sure my vfs programmer is working correctly...that's why I'm asking.

utieh

iTrader: (3)

Does someone have a direct link to the setting page on KO USA website?
I can't find this page from the home page anymore...
Does KO Japan has them too?
Thanks.

Gilles

utieh

iTrader: (3)

I'm looking for a tight asphalt mod set up
thanks

Wency_TA03R-PRO

Sure thing dude!!!..

Wency_TA03R-PRO

I agree with what hebiki stated above...