Hudy Comm lathe hints and Tips
I just bought a Hudy comm lathe with steel v guides. first off it says that i should use a source of 4.8 volts if useing a battery. Does this mean i must use a 4.8 volt source if i am using a dc power supply? My other question is is there any tips or tricks to using the thing. How much should i be taking of the armature at first.
Thanks |
Originally Posted by CREWMAN
(Post 4606266)
I just bought a Hudy comm lathe with steel v guides. first off it says that i should use a source of 4.8 volts if useing a battery. Does this mean i must use a 4.8 volt source if i am using a dc power supply? My other question is is there any tips or tricks to using the thing. How much should i be taking of the armature at first.
Thanks Try to remove only the tiniest amount needed to set the com true. Maybe .001 or .002 inches at a time. |
anyone know where i can get one fixed ? my daughter dropped ours and now its hard to turn the bit across the com.
|
All times are GMT -7. It is currently 11:30 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.