toptek

ok so in c1 and c2 you can set you personall settings. does it matter wich one you use?

BCbud

iTrader: (37)

No, you can use one or the other or you can put a different setup in each one and you do not need the hotwire to change between them.

Chemical X

iTrader: (18)

Sorry if this has already been covered, but can someone explain the procedure to switch between C1 and C2 without using HotWire? Thanks.

20 SMOKE

iTrader: (103)

push mode button 5 time led (TP) push INCS to led 6 (C1) led 7 (C2)

jeremy mac

iTrader: (11)

Hey guys ive just converted to a Tekin RS Pro and Redline 4.5 for touring mod. Ive downloaded the Vegas 212 software but i havent seen any other drivers set ups to use as a guide. I'm wondering if anyone can help me with a base set up to start with that i wont blow the motor with. Our track has about a 80-100ft straight.
Im guessing i wont need to run any boost or turbo with 4.5?

Any help will be appreciated.
Cheers.

toptek

Set your speedo in dual mode.
I used for a lrp x11 4,5t a timing of 40 to 45
gearing around the 8fdr.
On the Tekin site I notist that dual mode also is changed and that you can change the rpm range. Also just like the sensord mode 2 custom settings.

I can't waith till saturday to play with the speedo.
left my car ad the track.
It is a track in an old barn from a frend of me. we built there a track and now we race there with about 15 to sometimes 20 and even more racers.
next week the track will be bigger again. going to trow some junk out.
In the summer we drive outdoor. Outdoor I run mod.

put an extra cap on your speedo or a bigger one.
I use a 4700 v16

toptek

thanks I also found the info on the website.
can't wait to try the mod mode.

guinnes.s

what about the timing advance setting?

TrevCoult

The timing advance setting only applies if your sensor lead falls out, so don't worry about it.

See http://www.carsrcracing.co.uk/?p=244 for explanations of the settings.

Trev

2-Bad

iTrader: (24)

Hi... I'm new to these stock esc and want to place an order for one.

So apart from TT1153 RS Pro esc, is there anything else I need to order to use this esc?


Thanks.....

M-Technic

iTrader: (15)

You don't need the Pro if you are running stock. Only for mod touring is the Pro necessary. The normal RS is smaller and lighter.

You don't need anything else except possibly a HotWire so you can make setup changes via your laptop, and your own battery connector of choice to solder on. It comes with wire/leads and a capacitor.

vito c.

iTrader: (1)

hey guys,
can anyone help me with 17.5 set-up?
tc5,32/104 gearing
70-80ft straight
trinity t3 motor
carpet/rubber tire
very high traction
thank you
veetz

M-Technic

iTrader: (15)

Start with Hara's setup from Tekin's web site.

Randy_Pike

iTrader: (6)

http://www.teamtekin.com/hotwire/ESCsetups/index.html

toptek

Randy, why does Tekin not sponsor a driver like hara for mod?
why don't you sponsor a top 10 driver from Europe or Japan.
noting about the us drivers but in the us Tekin is already having good drivers.
would be nice to see hara race with the speedo in the mod class.