Tekin RS ESC sensored
09-23-2010, 09:07 PM
Hi guys, I have just uploaded the new software to the RS Pro in my 1/12th car, and just wanted know a 'base' setting for the speedo using a 10.5 motor in the car. Got it running really sweet with the 203 software, so could anyone help me out getting going with the 208 software, and then I can fine tune from there. Thanks very much in advance! Cheers.
-Mike
09-23-2010, 09:18 PM
Hot Bodies Cyclone (2.4375 IR) after balancing chassis 1480g. I not why I had to add that much weight 126g, no fan on motor, 17.5 Redline. I have tried just about everyone's profile at the track. FDR this weekend 1st round 6.5, 2nd 6.9, 3rd 6.4.
Boost: 45
Turbo: 14
Start: 4748
End: 13003
Turbo Ramp: 3
Throttle Profile: 3
Neutral Width: 10
Motor Timing: 0
Boost: 45
Turbo: 14
Start: 4748
End: 13003
Turbo Ramp: 3
Throttle Profile: 3
Neutral Width: 10
Motor Timing: 0
Boost: 45
Turbo: 15
Start: 27XX
End: 8500
Turbo Ramp: 2
Throtle profile: 3
Neutral Width: 9
Motor Timing: 8
Drag Brake: 20-25
Brake Strength: 90
FDR: 6.0
My motor temps aren't super high and the car has plenty of power on the low and top end. My car balances fine with the Exotek chassis and isn't as heavy as yours. What other electronics are you using? My car is1425 with a fan.
Last edited by STLNLST; 09-23-2010 at 09:27 PM. Reason: Bill kindly pointed out I forgot to put my turbo...LOL
09-23-2010, 09:23 PM
Forgot your turbo Mr. LST.
Bill
Bill
09-23-2010, 09:27 PM
09-23-2010, 09:29 PM
It's hell gettin' old isn't it?
09-23-2010, 09:32 PM
09-23-2010, 09:34 PM
hotwire version 208
After updating to 208 my Tekin RS is not working. Steering works but there is no throttle. There is also no response from either of the buttons on the esc. Anybody know how to go back to version 203? or maybe something else I could do to get it working? thanks
09-23-2010, 09:38 PM
Good day!
Did you recalabrate your radio to the speedo?
Did you recalabrate your radio to the speedo?
09-23-2010, 09:42 PM
Velotek, does the unit light up normally?
09-23-2010, 10:10 PM
no all the LED's are flickering which it says in the manual that that means a poor radio signal , but the connections ae good and the radio systemworks great with other ESCs. Also there is no response from eitherof the buttons.
Last edited by velotek1; 09-23-2010 at 10:21 PM.
09-23-2010, 10:24 PM
Is everything the same as when you had 203: car, battery and setup on the RS?
09-23-2010, 10:28 PM
09-23-2010, 10:32 PM
Try turning on the car befor the radio , this has worked for me when the speedo will not respond.
09-23-2010, 11:48 PM
Go into the software and check the cutoff voltage, this is almost always the reason after upgrading. The settings can change themselves after an upgrade, which can make the RS look like it isn't working when it it is just the settings.
If you need to, go through the common problems section of my article here.
http://www.carsrcracing.co.uk/?p=244
Trev
If you need to, go through the common problems section of my article here.
http://www.carsrcracing.co.uk/?p=244
Trev
Last edited by TrevCoult; 09-24-2010 at 02:56 AM.
09-24-2010, 02:39 AM
Zip ties weigh nothing, so one each end as close as you can to it being attached to anything is even better.