Skitee

Yes a cap is included in the box, the cap MUST be used because it smooths out spikes in the voltage supplied to the ESC under heavy acceleration and braking and it lowers the running temperature too.

20 SMOKE

iTrader: (103)

no

M-Technic

iTrader: (15)

Things Tekin has confirmed they are working on, but we have no idea when they will be available:

-v208 firmware
-new Hotwire GUI
-iPhone Hotwire interface

Krio

iTrader: (159)

They'll all be available Tuesday.

JCarr

iTrader: (2)

Would that be the second Tuesday of next week?

Skitee

Tuesday 30th February ?

20 SMOKE

iTrader: (103)

I said this before some where on here

It will be here between now and then,not sooner than now or later than then

Skitee

No worries Tekin, we still love you or I do anyway

Tomah

Hey again, i posted a month back about cogging with v203 firmware and not v200.

I've tried everything really, new sensor wire, new power cap.

Changed to another motor

ran on 0 timing and 0 boost so cant be a setting issue?

no matter what i try, i still cog on v203.

After all this, i set the speedo back to v200 and all works perfectly.

Im stumped?

20 SMOKE

iTrader: (103)

when changing motors did you change wire's

Tomah

Used a different sensor with the other motor (so tried 3) didnt change the A B C wires though? could this cause anything even if it works on v200 fine?

20 SMOKE

iTrader: (103)

did you check when it is cogging to see if the sensors are working by rolling the drive train and watch 5,6,7 led to see if they flicker

Tomah

Yep working. its not the sensor wire.

As i said, i can run the car fine on v200 firmware. So isnt a sensor wire problem

20 SMOKE

iTrader: (103)

usually going to a old version fixes funny issues,have you tried going back to 180 then back to 203

Tomah

still the same