Sorry to crash the thread but I've recently bought a Teamwave RB50 second hand and I don't think it's working properly.
The bloke I bought it off told me that it has been updated with the latest firmware, this rings true as not all of the numbers that appear on the handheld programmer display match the numbers printed on the firmware table (V1.10) when I plug it in.
The problem is that any brushless motor connected to it revs relatively slowly, I can't put a number on the amount of revs but it makes my car crawl along when on the track. The funny thing is that immediately after I have performed the radio set up procedure and apply full throttle on the transmitter the motor will rev' like mad for about 5 seconds before slowing right down. After this the motor will only rev slowly unless I perform the setup procedure again.
I've gone through the radio setup numerous times, I've tried different batteries, receivers, motors and even transmitters but it made no difference.
Does anyone have any ideas or is time to send it back for repair and start "beasting" the seller?
Any help would be much appreciated
P.S. Does anyone know where I can find a table of values for the latest firmware update (V1.1a) because at the moment I'm sort of guessing some of the figures?