pro3
#1096
Tech Apprentice
Now i found it, at last Thanks to you Tsubasa. Delivery will be middle of October...?? I think it is now..or..??
#1097
Tech Master
Originally posted by Proto pilot
Now i found it, at last Thanks to you Tsubasa. Delivery will be middle of October...?? I think it is now..or..??
Now i found it, at last Thanks to you Tsubasa. Delivery will be middle of October...?? I think it is now..or..??
Just send us a mail for more information.
[email protected]
#1098
oops - fell off the front page
#1099
does anyone know the part# of the HPI purple pulley (the one next to the spur gear and drives the rear)??? where is it available??? thanks.
#1100
PP3: i think doc lem has that part. try to contact him if its still available.
#1101
Originally posted by rc-zombies
HPI forum down again?
HPI forum down again?
#1102
Originally posted by purplepro3
does anyone know the part# of the HPI purple pulley (the one next to the spur gear and drives the rear)??? where is it available??? thanks.
does anyone know the part# of the HPI purple pulley (the one next to the spur gear and drives the rear)??? where is it available??? thanks.
Check the pic
I think its #72429 - HPI - Alum. Spur Gear Hub Set, PRO 3
It is a GREAT hop up, makes spur changes easy and you wont strip the thread like on the plastic part. Note that it uses the original plastic pully.
You should be able to get it at the usual stores in Hong Kong like control centre or rcmodel.
Cheers
Andy
#1103
wrxmy99: nope, not that. i am looking for the purple aluminum pulley that it is next to that
#1104
HPI don't make a purple small pulley for the rear belt.
And HPI's forum claims to be being changed for a "new system" - who knows how long that will take...
And HPI's forum claims to be being changed for a "new system" - who knows how long that will take...
#1105
sosidge: they do...i think rc zombies or pro3racing has it. i believe it was released by HPI Japan
#1106
Regional Moderator
Originally posted by purplepro3
sosidge: they do...i think rc zombies or pro3racing has it. i believe it was released by HPI Japan
sosidge: they do...i think rc zombies or pro3racing has it. i believe it was released by HPI Japan
and pully that was one of the first to come out and then hpi changed to the one that slipped on the plastic pully with the 4 screws to mount the spur gear because of stripping and then the the 3rd version which is shown in the picture below the screw on type. and the part was hard to get and came from japan only!
#1108
rc-zombies: thanks. would you by any chance know where i could get that part??? i am currently using the cross i piece pulley and spur mount...but it is not purple
#1109
Tech Elite
iTrader: (3)
Originally posted by rc-zombies
Is it this part #72417:
HPI discountinued it due to manufacturing flaws..
Is it this part #72417:
HPI discountinued it due to manufacturing flaws..
Does that make it the rarest HPI part ever produced?
Rare'er (is that a word?) than my HPI McLaren?
#1110
Tech Champion
iTrader: (7)
pp3: not purple?? oh no! i think you have to change your handle now to .... "notatotallypurplepro3" hehehe jk. you racing at the futaba cup this year? most likely moi, dale and greg will be joining (among others) since we can actually use our non Futaba tx/rx-es this year. finally! yipee!!!
Last edited by ROBORAT; 10-25-2002 at 02:17 AM.