Associated RC12R5
#2012
Tech Champion
iTrader: (34)
finished my 12r5.1 kit and I found that I need to space the wheels an extra 1mm each side to keep them even and to stop the rear left (non-diff side) wheel from rubbing against the rear pod. I am using Jaco Yellow on prism rims. Once shimmed 1mm each side the rear width is 171mm.
Also one slight issue, which im hoping will bed down on its first run tomorrow, is that kingpins dont seem to have a smooth action through the arms. I made sure all the plastic pivot balls were pushed in the correct way.
I have no lube on them at the moment.
Any ideas? or will this smoothen out after a run or two.
Also one slight issue, which im hoping will bed down on its first run tomorrow, is that kingpins dont seem to have a smooth action through the arms. I made sure all the plastic pivot balls were pushed in the correct way.
I have no lube on them at the moment.
Any ideas? or will this smoothen out after a run or two.
#2013
Tech Adept
Thanks.
Shining the king-pin has helped a lot, but you are right that the balls aren't freely rotating.. 1 is but the rest stick or are stiff.
Ill try popping them in and out a few times to make sure there is no mould marks, and ill try adding some com drops or other lube.
Shining the king-pin has helped a lot, but you are right that the balls aren't freely rotating.. 1 is but the rest stick or are stiff.
Ill try popping them in and out a few times to make sure there is no mould marks, and ill try adding some com drops or other lube.
#2014
I just started using 1s lipo in my 12R5.1, should I change the front, center and side springs? What color? Change shock oils? Weight?
#2017
I can not find the setup on ae does any one have a link.
#2018
Tech Adept
Check this page out for setups. Its where I got mine from
btw im not able to post links yet, until i met a post limit, so you will have to follow these instructions.
go to petitrc.com
browse the left until you see setup sheets and manuals, click that. Then find 12r5
Loads there for different grip, surface.
btw im not able to post links yet, until i met a post limit, so you will have to follow these instructions.
go to petitrc.com
browse the left until you see setup sheets and manuals, click that. Then find 12r5
Loads there for different grip, surface.
#2020
thank you for the links
#2021
all of my setups are on the website. The best setup i have found is the one under this years indoor champs. This also works very good in 13.5 and 10.5. It has not been tested in 17.5. setup is 2009 us indoorchamps.
here is the link to the setups . then search drivers look for me or set it for the car.
http://67.199.85.166/racing/setups.php
Mike
here is the link to the setups . then search drivers look for me or set it for the car.
http://67.199.85.166/racing/setups.php
Mike
#2024
thinkin of a 1/12th scale.. found a decent deal on 5r I spend some time trying to figure out the differences from 5 to 5.1... can 5.1 parts be obtained to update the 5?
Thanks.
Thanks.
#2025
left and right pod plates, pod brace and graphite upper pod plate. Note: if the car does not have the 10r pod plate conversion you will also need the wider lower graphite pod plate.
I think that's all...
E