Hudy plexiglass 1/10 setup station ?
#1
Hudy plexiglass 1/10 setup station ?
Anyone have one of these Hudy setup stations
http://www.hudy.net/eshop/products/p...3&kategoria=64
It is made of plexiglass and obviously less expensive.I'm just trying to keep the cost down a little bit,but if it is not worth it then i wll go with the aluminum setup.Comments and suggestions are welcome.
http://www.hudy.net/eshop/products/p...3&kategoria=64
It is made of plexiglass and obviously less expensive.I'm just trying to keep the cost down a little bit,but if it is not worth it then i wll go with the aluminum setup.Comments and suggestions are welcome.
#2
i think you can get the speedmind in alum. for pretty close to the same price if you already have a set-up board, or you can buy a piece of think plexi from like a home depot or something if trying to save a couple bucks
#3
Speedmind ?.I never heard of that brand,but i will start searching now.If ya come across a link,pass it on please.The board is something i will get on the side,either one of the custom ones sold here in the sell/trade forum or like you said home depot.All i need after that is the decal sheet for the board.
#4
http://www.speedtechrc.com/store/ebp...id=384&id=6411
it might be out of stock on this site but it gives you a look . . .
it might be out of stock on this site but it gives you a look . . .