nikoskar

Speed Passion BL Competition 2.5R


SP13825 Competition 2.5R


It corresponds to the brush less speed controller of LRP. Referring to the use range the specifications of each ESC.
* Note *
Motor installation bis: You strictly observe to 6mm front bell screwing in depth 4mm
Because competition 2.5R is a possibility ESC receiving the damage, 5 cells (6.0V) please use in the limit.

The cooling fan was built in inside the rotor, so far the heat sink which is indispensable and the necessity to load the cooling fan of external was gone. It is the completion of competition level the wide power band, super long life, in everything.

- Sensor technology
- Temperature protection network
- Hand wind
- Shaft diameter: 3.175mm
●IFMAR regulation correspondence
●540 size
- Cooling fan built-in rotor




- The cooling hole it is efficient, holds down temperature rise.


- Sensor cable 90mm attachment



Source: http://www.powers-international.com/...on/sp13835.htm