esc question
i have a brand new lrp brushless tc esc, when i turn the system on the motor runs for a few minutesthan stops. is this a programing issue? if it is which setting should i look at? thanks for the help.
chris |
Your battery sounds like it is either not high enough mAh (affects current) or just way too old.
I know LiPo setups demand high current batteries that come with high mAh ratings. How old are the batteries, and how's the mAh? If it's running for a few minutes then stopping I believe that the mAh is just way too low, or your charger has some issues. The Built in BEC will cut off the voltage after the voltage drops below a rating. |
The default battery profile is set to Auto Lipo. If you are running NiMH's, change the battery profile to #2 instead. Hope this helps!
|
All times are GMT -7. It is currently 09:39 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.