Tamiya 11T motor
#1
Tech Apprentice
Thread Starter
Tamiya 11T motor
Has anyone experienced this before and what should I do?
I have only ran about 5 packs with this motor the brushes are fine so is the commutator.it still stops after a few seconds and does not want to go again, if I put anotherone in works just fine.
What the heck is this?
I have only ran about 5 packs with this motor the brushes are fine so is the commutator.it still stops after a few seconds and does not want to go again, if I put anotherone in works just fine.
What the heck is this?
#2
it might be the ESC or somone is using the same crystal as you...or maybe the line that feeds the brush in is caught on something...happened to one of my motors
#3
Tech Apprentice
Thread Starter
What do you mean by this:the line that feeds the brush in is caught on something...and what can I do to fix it?
#4
I think he means the peice of wire attached to the brush is catching on something .. eg the solder tabs ..
Or you may have sticky brushes. try removign the springs and moving the brush in and out a few times as There may be dirt in the hoods.
Or you may have sticky brushes. try removign the springs and moving the brush in and out a few times as There may be dirt in the hoods.
#5
Tech Apprentice
Thread Starter
That was helpfull, now I got it!
THANX!
THANX!
#6
No worries