Is it time again for 1/10th scale pan cars?
#283
Tech Adept
I actually prefer metric but right now all my settings for cutting in SAE. I need to create another profile and get all the metric settings to cut acurately. Once I do that then will be able to cut either.
Since what a lot of what I do is wood work, here in the US everyone's drawings are in SAE so I am getting that profile 100% acurate first.
Once the gantry is finished and if you some something I can test and open in Turbocad Deluxe ver. 14, willing to give it a try. Just will be some time before I am ready. My guest leave at the end of the week, then in between work and busy social life will get everything fixed. Love doing the machining of the parts....
#284
Tech Adept
When my routing table gets the other 2 axis setup it will have a C & A instead of the C & B shown in the previous picture. This will allow machined axles and hub cariers to be made. Or even custom hex nuts for touring cars and other RC's.
I figure motor plates, top and bottom chassis plates is where I would start with pan car stuff though. Get the two cars I posted pictures of and see if I can draw and remake same parts and then start customizing to something new from there.
I figure motor plates, top and bottom chassis plates is where I would start with pan car stuff though. Get the two cars I posted pictures of and see if I can draw and remake same parts and then start customizing to something new from there.