I've been trying more mods on the S400 to keep the enthusiasm up before the S401 becomes available. Below are are few pics with ideas implemented.
Second S400 gear diff installed on front with machined 2mm alloy shims to centre in bulkheads.
Front rear toe/suspension block now mounted flat for better strength with more than adequate clearance for belt with tentioner mounted just behind steering belt crank instead on top deck. This allows belt to run high enough to clear hinge pin mount. Even if roll centre shims are used.
Picture of belt tentioner now mounted just behind steering crank.
This shows amount clearance of belt.
Antenna also is now mounted on chassis instead on top deck as well i have fitted a EXOTEK LiPo brace to keep the LiPo position secure along the chassis line of the car.
You can tell i have too much time on my hands !!