They call this a PRO????
02-23-2003, 05:38 PM
#1
They call this a PRO????
I am building a monster stock motor for my dad, he bought a trinity monster stock PRO armature, I take it out of the package and the package, open the armature tubeand the first thing I see is a large scratch on the comm...... then I notice several scuff marks on the comm also!!!
Then I notice one of the wires leading from the comm to the stacks is loose also!!!!!!
Trinity says their pro arms are trued from the factory, so why does this one have a large scratch and scuff marks on it!!! This is quite pathetic, even for Trinity!!!!
Then I notice one of the wires leading from the comm to the stacks is loose also!!!!!!
Trinity says their pro arms are trued from the factory, so why does this one have a large scratch and scuff marks on it!!! This is quite pathetic, even for Trinity!!!!
02-23-2003, 05:47 PM
#2
Tech Rookie
That is pathetic. I would send it back.
02-23-2003, 05:52 PM
#3
Return it with a nasty gram attached.
02-23-2003, 05:56 PM
#4
You could always return it with a NICE letter explaining the problem. I'm sure Trinity or the retailer you bought it from will replace it.
02-23-2003, 06:55 PM
#5
Tech Elite
That is pathetic. I would send it back
Always NICE first. If they get Sh____ with you then get NASTY. But try being NICE first.
02-24-2003, 12:59 AM
#8
trinity isnt too bad for replacing things, the vblocks with my lathe were no good and they sent me some straight away.
02-24-2003, 06:28 AM
#9
Yea, I'm gonna talk to my dad and see what he wants to do, unfortunately I think my brother needs this motor for the weekend....
But this makes me wanna tear my new monster apart and check it out, even though it is in my "parking lot toy" which I use to race non-competetively........
But this makes me wanna tear my new monster apart and check it out, even though it is in my "parking lot toy" which I use to race non-competetively........
02-24-2003, 11:16 AM
#11
Re: They call this a PRO????
Originally posted by IMPACTPLAYR
Then I notice one of the wires leading from the comm to the stacks is loose also!!!!!!
Then I notice one of the wires leading from the comm to the stacks is loose also!!!!!!
02-24-2003, 11:48 AM
#12
Tech Master
I know what you mean impactplayer, I ordered some "pro" P2K2 arms from my LHS a couple months ago and not one of them was drilled to balance the arm.
02-24-2003, 12:11 PM
#14
Re: Re: They call this a PRO????
Originally posted by MarkA
I've seen a few with loose wires/windings now. The quality control on these motors is definitely a new low, even by Trinity's standards.
I've seen a few with loose wires/windings now. The quality control on these motors is definitely a new low, even by Trinity's standards.
-Dave
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
