motor
As I am breaking my motor in (19Turn) at 2 volts and 5.40 amps, then as I increase it to 7 volts and 8.00 amps, my motor starts to vibrate and numbers start to jump up and down, what does the mean
Big Papa :smile: |
Your armature is not perfectly balanced (not very fixable unless you are willing to drill some material away) and causing the brushes to bounce; this causes arching, and funky amp draw numbers. Generally, the motor will run fine in your car, but not nearly as efficient and powerful as a motor that is perfectly balanced.
|
might want to try skiming the com too , as well as what was mentioned ,checking the balance of the arm ... I had a 19t do the same thing , cut the com and did notice the com being out of round ....motor now runs fine ....
|
Why would you want to break in your motor at 7v? Stick with 1-2v.
|
All times are GMT -7. It is currently 09:36 PM. |
Powered By: vBulletin v3.9.3.8
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.