old_dude

iTrader: (1)

That's it.

nova2015

iTrader: (5)

g'day guys, is there a page for the Cero FWD?

old_dude

iTrader: (1)

I came across a issue when putting the alloy chassis on my v2. I don't run shims under my lower pivots. Well iin front I found that the shock cap hit the shock mount limiting down travel when the shock also had no shims. A little grinding of the mount fixed this.

Razathorn

iTrader: (2)

What alu chassis?

jtthebiggafigga

Can someone give me some advice on why to change the thickness of the lower arm shims front and rear. I'm running the kit setup on unprepped asphalt with yokomo 28A rubber and a 8.5t. The car drives nice but I could use more on power traction at the rear. I removed the rear sway bar completely and it helped a little but I still could use more rear end grip. I realize this is a lot of power and nothing will make it grip under power like a 25.5 or 21.5. With such low grip I imagine I don't want to lower the roll centers much but I am still a rookie at on road setup. I understand the theory from reading literature on real race car design and tuning, but I have very little actual tuning experience on touring cars. I'm thinking raise rear roll center maybe?

old_dude

iTrader: (1)

3Racing. They just became available. I was changing from the graphite to it when I found the shock cap issue.

jahlion247

iTrader: (1)

3racing Cero ultra V2 versus 2014 Xray T4?

go!

old_dude

iTrader: (1)

Cero Ultra 2.0 with the alloy chassis for sure.

jahlion247

iTrader: (1)

Any recommendations for a good USA hobby shop that sells these?

Rvogt

Tqrracing.com racevta.com

jahlion247

iTrader: (1)

Cool.racevta.com is in St. Petersburg Florida.

I'm in Spring Hill, Florida often.

Thanks!